Reeflor EL002 S/F - Self Smoothing Solvent Free Epoxy Flooring
Vendor: Virtus Resins
Reeflor EL002-SF is self-smoothing epoxy based industrial floor topping.
Reeflor EL002-SF is suitable for use where a hard wearing; dust free; hygienic, easy clean floor topping is required. Ideal situations include industrial or commercial floors, laboratories, car showrooms, gangways etc.
Reeflor EL002-SF is a 1.5 - 4.5mm floor topping with advantages to both contractors and clients. All resins, curing agents and aggregates are supplied pre-weighed ready for use on site.
- Self Smoothing
- Good Chemical
- Solvent Free
- Wide Colour Range
- Hard Wearing
1.75 kg / m² minimum. 24.5 kg pack will cover up to 7m² @ 2mm thick.
Drying times for light foot traffic is 1 day, lightly serviceable is 2 days and fully serviceable is 7 days.
All floors must be thoroughly sealed with Reeprime EP550 prior to the application of Reeflor EL002-SF.
New concrete should have an RH% of 75% or less. The substrate should be clean, free from laitence, oil, grease or other agents, which may impair adhesion. Cleaning techniques may include acid etching, grinding, light mechanical scabbling, blasting or degreasing, depending on wall contamination.
Existing concrete floors should be sound and free from loose material. Damaged areas should be repaired with a Reepare Mortar prior to the coating application.
Cementitious substrates should be sound and of sufficient compressive strength (min. 25 N/mm² ) and a minimum pull off strength off 1.5 N/N/mm² .
Priming must be carried out with Reeprime EP550. All floors must be thoroughly sealed with Reeprime EP550 or Reeprime RBS80 prior to the application of Reeflor EL002 S/F. It is always preferable that the sealing is carried out in one application by depositing sufficient primer. Depending on the porosity of the substrate a second coat may be required. Reeprime must be tack-free before the application of Reeflor EL002 S/F.
Joining time should not exceed 35 minutes at temperatures of 18-20°C and 45 minutes at 12-18°C. Disturbances to the applied materials outside of these timings may create streaking and discolorations at the joining point..
All existing joints in the substrate should be followed through into the Reeflor EL002 S/F.
Storage, Mixing & Application:
The entire contents component B should be added to the entire contents of component A, and should be mixed together using a low speed electric stirrer (300-400 RPM) for a minimum of 3 minutes until a uniform mix has been achieved. Transfer to suitable sized mixing bucket scraping well the sides of the container. Gradually add aggregate component C while mixing. Continue mixing for 2 minutes or until a uniform mix has been achieved. Pour the mixed material onto the pre-sealed substrate and spread to the required level by steel trowel. Roll immediately in two directions with a spiked roller.
The Storage, mixing and application conditions can affect the quality of the finished product. Please refer to our Information Data sheet ref. TD300.
Certain colours can be made to order subject to availability.
|BEIGE||YELLOW||HOLLY GREEN||LEAF GREEN|
|ELFIN GREEN||CARNIVAL RED||TILE RED||STORM GREY|
|FLINT GREY||GOOSEWING GREY||LIGHT GREY||TARTAN BLUE|
|CORNFLOWER BLUE||PIGEON BLUE||WHITE||BLACK|
Safety Data Sheets