
Reepol DPM - Damp Proof Membrane
Vendor: Virtus Resins
Available
Reepol DPM is a two component, solvent free damp proof membrane designed for use as a coating over cementitious surfaces which have a moisture content above 75% Relative Humidity. This practice should only be adopted subject to a survey confirming adequate underlying ground stability.
Typical Installations
An effective moisture suppressant membrane for over sealing cementitious surfaces which contain high levels of residual moisture. Permits early overlaying with vinyls, carpets and resin based products without the conventional “drying out” period being observed. Also suitable as an overlay DPM to cementitious surfaces which were laid without under laying DPM.
Durability
Excellent Long term hydrolytic stability when used as a moisture repellent membrane/coating. Good resistances to general chemical contact.
Appearance
Full gloss film, tinted in two colours. Buff for first coat. Grey for second coat.
Thickness
As a two coat system – 400-500 microns composite build.
Coverage
140g/m² - single application.
Overcoating Period
24 hours.
Surface Preparation:
To be assured of maximum adhesion and properties from Virtus Resins products, the correct surface preparation is essential. Please refer to technical data sheet “Surface Preparation” TD112.
Specification Details:
Two coats of 200 microns per coat. 16-18 hours between coats. Second coat to be applied at right angles to first.
Storage, Mixing & Application:
The storage, mixing and application conditions can affect and specific health and safety data for this product provided in compliance with the requirements of EC Directive 91/155.
Mixing
Thoroughly drain contents of hardener bottle into resin container and mix thoroughly for a minimum of 3 minutes or until a homogeneous mix is obtained. Pay special attention to scrape sides and base of container.
Technical Datasheets
Reepol DPM
Safety Data Sheets
Reepol Component A
Reepol Component B