Flowgrout SF - Epoxy Grout

Vendor: Virtus Resins
Flowgrout SF is a specially designed thixotropic seal coat and grout for highly filled epoxy resin screed systems. It is used to grout the upper surface of these systems to...

Available

With VAT: £59.60 | Without VAT:
£49.67
Size
Color
Black
Charcoal
Mid Grey
Dark Grey
Light Green
Green
Chelsea Blue
Midnight Blue
Light Grey
Platinum
Steel
Slate
Safety Red
Tile Red
Sahara
Yellow
Safety Yellow
Buff
Light Blue

Flowgrout SF is a specially designed thixotropic seal coat and grout for highly filled epoxy resin screed systems. It is used to grout the upper surface of these systems to provide a non-porous surface layer which can be finished with an appropriate wearing coat.

Surface Preparation

Inadequate preparation will lead to loss of adhesion and failure. Grinding, light vacuum-contained shot-blasting or planing is recommended.

Coverage

Approximately 0.25kg per sqm for the 1st coat and 0.15kg per sqm for the 2nd coat.

Drying Time

At 20 degrees, curing time for foot traffic is 24 hours and for heavy traffic is 48 hours.

Thickness

Typically 200 - 300 µm. Most of the grout is forced into the pores of the underlying screed leaving very little on the surface.

Primer

No primer required.

Application Conditions:

Ideal ambient and substrate temperature range is 15 - 25 ºC. Localised heating (electric powered warm air blower) or cooling equipment may be required outside this range to achieve ideal temperature conditions. The substrate and uncured floor must be kept at least 3 ºC above the dew point to reduce the risk of condensation or blooming on the surface, from before priming to at least 48 hours after application.

Mixing:

Prior to mixing, the temperature of the three components must be between 15 and 25 ºC. Pre-mix the coloured resin component before use. Add the hardener component to the coloured resin component and mix using a low speed electric mixer (300 - 400 rpm) for 1 - 2 minutes until homogeneous. Care should be taken to ensure that any material adhering to the sides and bottom of the mixing vessel is thoroughly mixed in.

Application:

Apply Flowgrout SF using a dense polypropylene squeegee to force the seal into the surface and to grout any open areas. Scrape off any excess to leave the surface with an thin, even film. Finish by back rolling with a semi-dry roller. If, when cured, there are un-filled patches, conduct a further application. Flowgrout SF should be applied to the cured resin screed within 24 hours of application. Failure to do so may result in de-bonding. Flowgrout SF should be over-coated with the chosen finish coat within 24 hours for the same reasons.

Certain colours can be made to order subject to availability

BLACK CHARCOAL MID GREY DARK GREY
LIGHT GREEN GREEN CHELSEA BLUE MIDNIGHT BLUE
LIGHT GREY PLATINUM STEEL SLATE
SAFETY RED TILE RED SAHARA YELLOW
LIGHT BLUE SAFETY YELLOW BUFF

Technical Datasheets

Flowgrout SF

data sheet download


Safety Data Sheets

Flowgrout SF Coloured Resin

data sheet download

Flowgrout SF Hardener

data sheet download

Related Product

Best Sellers

Suppliers & Partners