Flowmaintain Floor Repair

Vendor: Virtus Resins

Flowmaintain Floor Repair is a low odour polyurethane concrete which has been specifically designed to provide an easy to use floor patching compound with excellent physical properties for use on...

Available

With VAT: £80.40 | Without VAT:
£67.00

5 Kg

10 kg

Subtotal:

Quantity

Coverage Calculator

Do you know the size of the area?

Area M² Recommended Thickness Calculate

Flowmaintain Floor Repair is a low odour polyurethane concrete which has been specifically designed to provide an easy to use floor patching compound with excellent physical properties for use on concrete and polymer modified cementitious screeds. Flowmaintain Floor Repair is designed with the highest order of durability, impact and abrasion resistance.

Advantages

Resin rich - easier and quicker to apply than stiffer screeds.
Good chemical resistance
High abrasion resistance
Cures at low temperatures
Impact resistant
Unlike epoxy mortar compounds which can be sticky to apply, Flowmaintain Floor Repair has a similar consistency as a cement based mortar and can be placed and trowelled to a closed finish.

Surface Preparation

Inadequate preparation will lead to loss of adhesion and failure. Surfaces should be clean and free of any loose material, oils or contamination.

Resistant to: Flowmaintain Floor Repair is designed with the highest order of durability, impact and abrasion resistance.

Coverage

10 kg covers approximately 1sqm at 5 mm thickness

Drying Time

Cure time to light pedestrian traffic is 6 hours. Cure time to light wheeled traffic is 24 hours.

Thickness

5 – 10 mm

Primer

Flowmaintain Floor Repair contains a small percentage of water and will tolerate application onto slightly damp, but not wet, surfaces. Dry, porous surfaces should be primed using Flowprime TC.

Surface Preparation:

Inadequate preparation will lead to loss of adhesion and failure. Surfaces should be clean and free of any loose material, oils or contamination.

Priming:

Flowmaintain Floor Repair contains a small percentage of water and will tolerate application onto slightly damp, but not wet, surfaces. Dry, porous surfaces should be primed using Flowprime TC.

Application Conditions:

Ideal ambient and substrate temperature range is 15 - 25 ºC. The substrate and uncured floor must be kept at least 3 ºC above the dew point to reduce the risk of condensation or blooming on the surface, from before priming to at least 48 hours after application.

Mixing & Application:

Add the hardener component to the resin component and stir thoroughly until an even consistency. Decant the mixture into the plastic bucket provided and mix using a using a low speed electric mixer (200 - 500 rpm) gradually adding the aggregate component whilst continuing the mixing action. When all the aggregate has been added, mix for a minimum of 3 minutes until a uniform, lump-free mix is obtained. Care should be taken to ensure that any material adhering to the sides, bottom and corners of the mixer is thoroughly blended in. Apply to pre-prepared areas to the required thickness using a steel float.

Available in natural or in a standard range of colours. Standard colours available as subject to minimum 20 pack size order: Mid Grey, Green, Tile Red, Yellow, Chelsea Blue.