Flowgrip HD2 - Resin Binder

Vendor: Virtus Resins
Flowgrip HD 2 is a two-component flexible binder which when scattered with natural or synthetic aggregates creates a slip resistant profiled surface suitable for car parks, ramps and pedestrian areas....

Available

With VAT: £204.00 | Without VAT:
£170.00
Coverage Calculator
Calculate

    Flowgrip HD 2 is a two-component flexible binder which when scattered with natural or synthetic aggregates creates a slip resistant profiled surface suitable for car parks, ramps and pedestrian areas.

    Applications

    Flowgrip HD 2 is suitable for use on concrete, polymer modified sand/cement screeds, suitable asphalt, wood and steel surfaces. With the wide choice of natural and synthetic aggregates available, patterns and logos can be easily created.

    Features & Benefits

    • Two pack - easy to use
    • Hardwearing, tough and slightly flexible
    • Seamless
    • Rapid installation / minimal downtime

    Coverage

    1.4 kg/m² per mm thickness.

    Curing Schedule

    Cure time to light pedestrian traffic is 6 hours and to heavy duty traffic is 24 hours.

    Application Conditions:

    Flowgrip HD 2 can be applied at temperatures between 5 - 30 ºC. At low temperatures the material will exhibit less flow than at warmer temperatures and may be more difficult to apply at low thicknesses. The maximum atmospheric relative humidity should be 75%.The substrate and uncured floor must be kept at least 3 ºC above the dew point to reduce the risk of condensation or blooming on the surface, from before priming to at least 24 hours after application. Surfaces must be completely dry before installation otherwise the material may blister and/or de-bond.

    Mixing:

    Prior to mixing, the temperature of both components should be between 15 and 25 ºC . Add the hardener component to the beige resin component and mix using a low speed electric mixer (300 - 400 rpm) for at least 3 minutes until homogeneous. Keep the mixing paddle fully submerged to avoid the entrapment of air and scrape the sides and bottom of the vessel several times. Decant the mixed material to a second mixing vessel and mix as above for a further minute.

    Application:

    Distribute the mixture immediately onto the surface using a steel float, pin rake or squeegee and spike roller thoroughly within 5 minutes to remove trapped air. Plan the work area to ensure a constant wet edge and work within the working time of the material. Broadcast the aggregate into the binder within 15 minutes of mixing in thin layers until a stone-rich surface has been achieved. Monitor the broadcast area to ensure that any bare areas which may appear are re-broadcast promptly. The excess aggregate can be swept off as soon as the binder is hard enough to accept foot traffic.

    Technical Datasheets

    Flowgrip HD2 Resin Binder

    data sheet download


    Safety Data Sheets


    Flowgrip HD2 Resin

    data sheet download

    Flowdur HD2 Hardener

    data sheet download

    Related Product

    Best Sellers

    Suppliers & Partners