Flowseal P2 Clear - Polyurethane Sealer

Vendor: Virtus Resins
Flowseal P2 is a single pack, flexible but highly abrasion-resistant polyurethane floor seal for application to concrete, wood, grano and composition flooring. Appearance Water white in colour, recommended for wood...

Available

With VAT: £112.09 | Without VAT:
£93.41
Size
Coverage Calculator
Calculate

    Flowseal P2 is a single pack, flexible but highly abrasion-resistant polyurethane floor seal for application to concrete, wood, grano and composition flooring.

    Appearance

    Water white in colour, recommended for wood and surfaces requiring no colour change. Provides a clear gloss finish.

    Surface Preparation

    To be assured of maximum adhesion and properties from Virtus resin products the correct surface preparation is essential. We recommend shot blasting to give the floor a key and diamond grinding to remove old tougher coatings.

    Cleaning

    Flowseal floors can be readily cleaned by mopping with a proprietary detergent solution.

    Thickness

    Average of 60 μm per coat.

    Durability

    P2 has an extremely high abrasion resistance and will withstand heavy traffic for prolonged periods. It is considered superior to conventional oil and water-based floor paints.

    Typical Installations

    Flowseal P2 not only seals but penetrates old and porous concrete acting as a strengthening binder and reinforcer. It is ideal for use as a sealer in warehouses, storage areas, trucking lanes etc.

    Suitable Substrates

    Flowseal P2 bonds well to concrete, grano, wood and metals. It should not be used directly on asphalt without prior priming with Flowprime D.S.

    Application Conditions

    Flowseal contains solvents and should only be used in well-ventilated areas.

    Application temperature: 0-30° C.

    Maximum moisture content: - 75% RH.

    Technical Information

    Resistant to Flowseal P2 exhibits good resistance to a wide range of chemicals, oils, petrol etc., but it is not recommended as a chemical resistant finish. Floor seals can be readily damaged by impact and chemicals can then attack the concrete from underneath the seal.

    Coverage: 8 m² per kg. On porous, uneven concrete apply 2 or 3 coats of Flowseal P2.

    Drying Time

    At 20 degrees, it will be suitable for foot traffic after 16 hours, heavy traffic after 36 hours and full cure within 3-4 days.

    Primer

    Flowseal P2 does not usually require a primer but on well compacted non-porous concrete, an addition of 20% Flowsolve is recommended to assist penetration of the first coat.

    Composition

    Flowseal P2 is a high solids, high flash point (44°C), solvent containing polyurethane liquid of low viscosity.

    Application Techniques

    Transfer the mixed product into a paint tray and apply by brush or roller, pushing the Flowseal out as thinly as possible. Avoid “pooling” as this will produce soft spots

    APPLICATION CONDITIONS

    Flowseal contains solvents and should only be used in well ventilated areas. Application temperature 0-30° C. Maximum moisture content of 75% RH.

    PRIMING

    Flowseal does not usually require a primer but on well compacted non-porous concrete, an addition of 20% Flowsolve is recommended to assist penetration of the first coat.

    APPLICATION TECHNIQUES

    Transfer the mixed product into a paint tray and apply by brush or roller, pushing the Flowseal out as thinly as possible. Avoid “pooling” as this will produce soft spots

    Technical Datasheets

    Flowseal P2 Technical Data Sheet

    data sheet download


    Safety Data Sheets


    Flowseal P2

    data sheet download

    Related Product

    Best Sellers

    Suppliers & Partners