Flowcast - Clear Epoxy Self-Leveller
Vendor: Virtus Resins
Flowcast - 2-part, self-smoothing epoxy screed.
Advantages
- UV-stable
- Can be built up to 15mm thick (multiple pours may be required)
- Clear Gloss finish
- Self-smoothing
- Does not require priming
- Indoor use
Colour
Transparent /Clear
Finish
Smooth gloss finish
Coverage
1kg = 1mm over 1sqm. Recommended minimum thickness is 2-3mm.
MIXING RATIO:
By weight: 100 + 40, By volume 2 + 1
Note: The mixing ratio must be accurately followed. It is not possible to change the ratio.This would result in lower mechanical properties and the resin not drying properly. The mixture should be thoroughly stirred to ensure full homogeneity. Epoxy systems tend to heat up much faster in a pot than as a thin film. Therefore mix only the necessary amount usable within the given pot life.
Application
The product generates exotherm when mixed in larger volumes, and becomes unusable very quickly. We recommend that small amounts are mixed initially (2 kg), and once you are more confident and understand the product, amounts can be increased to a maximum of 5-7 kg at a time.
LEVEL
Ensure your piece is perfectly flat and level, otherwise the resin will run to the lowest point and “pool” in the centre, leaving too little resin at the corners. On large canvas paintings / pictures you should tighten the canvas as much as possible or place a board underneath to support it uniformly.
Any bubbles created by hand-mixing can be easily popped by using a sharp object or by passing warm air over the surface of the resin (e.g using a blowtorch or hot air dryer on slow speed setting).
Don’t hold the blowtorch or hot air blower closer than 30 cm to your floor otherwise you risk creating ripples and dimples in the resin finish.
DUST
You will need to protect the piece from dust accumulation for at least 12-24hrs. You can do this by using a dust sheet or a box to cover the piece. The system can be applied by hand pouring or by brush / roller. The resin can be tinted any colour with the addition of pigments available in solid and metallic effect colours. Mix in the ratio of 2:1 (by volume) until it is a uniform colour and consistency (usually 3-4 mins).
SEALING COAT
If the material you are pouring Flowcast onto is not porous, for example plastics, metals, marble or granite then you do not need to seal the surface. If the material you will be pouring Flowcast over is porous such as wood, chipboard, MDF or ceramic materials then it is highly recommended to apply a sealing coat before the main pour. Doing so will improve the flatness of the final surface and help to eliminate warping of the substrate after cure. Mix around 500 g of Flowcast per square metre of surface you need to seal. Don’t worry if most of the resin seems to be absorbed by the substrate; this is normal for the sealing coat. Allow the ‘sealing coat’ to cure before proceeding. Depending on the ambient temperature, this is likely to take around 24 - 48 hrs. It should feel hard and not at all tacky. In order to ensure that the next layer of Flowcast bonds well to the sealing coat it is necessary to ‘key’ the surface of the sealing coat using some coarse abrasive paper. This will also help to flatten off any slight raised texture where the substrate has absorbed some of the sealing coat. Don’t worry that the surface then looks scratched and light in colour - this will disappear as soon as the next layer of resin is poured.
Technical Data
Flowcast Technical Data Sheet