Flowdur WR - Polyurethane Wall Render
Vendor: Virtus Resins
Flowdur WR is a seamless polyurethane mortar for application to vertical surfaces and for forming radius coves. Flowdur WR is designed with the highest order of durability, abrasion and chemical resistance (when sealed). Its easy to clean matt finish makes the product ideal for environments such as the food, beverage, engineering and chemical industries.
Appearance
Lightly textured matt finish.
Surface Preparation
Inadequate preparation will lead to loss of adhesion and failure. Substrates should be clean, dry, sound and free of surface laitance.
Coverage
100 mm x 50 mm x 6 mm cove (2” radius) - 5.04 linear metres per pack.
Cleaning
Regular cleaning is essential to enhance and maintain the life expectancy and appearance of the product. Flowdur WR can be easily cleaned using industry-standard cleaning chemicals and techniques, especially where sealed using Flowdur TF.
Thickness
Typically 2 - 9 mm
Primer: Flowdur WR should be applied into tacky Flowprime TC (typically 45 - 60 minutes after application). If prior to application of Flowdur WR, there are dry patches, a further primer coat is required. If the primer has been left to cure for >48 hours then the primer surface should be mechanically abraded and the area re-primed.
Sealing: Due to the dry nature required of a product designed to be applied vertically, Flowdur WR shows a lower colour strength than flooring materials and colour density may vary throughout an installation. Where a closer colour match is required or where Flowdur WR requires sealing, for example, in wet areas or where chemical spillages are likely, Flowdur TF should be applied within 24 hours of application.
Application Instructions & Priming
Flowdur WR should be applied into tacky Flowprime TC (typically 45 - 60 minutes after application). If, prior to application of Flowdur WR, there are dry patches, a further primer coat is required. If the primer has been left to cure for >48 hours then the primer surface should be mechanically abraded and the area re-primed.
Application of Flowdur WR
Prior to mixing, the temperature of the three components must be between 15 and 25 oC. Pre-mix the coloured resin component before use. Add the hardener component to the coloured resin component and mix using a low speed electric mixer (300 - 400 rpm) for 1 - 2 minutes until homogeneous. Decant the mixture into a rotary drum mixer and add the aggregate component in stages, mixing for a minimum of 3 minutes until a uniform coloured, lump-free mix is obtained. Apply the mixture immediately onto pre-primed areas using a coving trowel to form skirting if required. Avoid excessive tooling which may lead to ‘trowel burn’. Sealing Due to the dry nature required of a product designed to be applied vertically, Flowdur WR shows a lower colour strength than flooring materials and colour density may vary throughout an installation. Where a closer colour match is required or where Flowdur WR requires sealing, for example, in wet areas or where chemical spillages are likely, Flowdur TF should be applied within 24 hours of application. See separate technical datasheet
Certain colours are subject to availability
BLACK | CHARCOAL | MID GREY | DARK GREY |
LIGHT GREEN | GREEN | CHELSEA BLUE | MIDNIGHT BLUE |
LIGHT GREY | PLATINUM | STEEL | SLATE |
SAFETY RED | TILE RED | SAHARA | YELLOW |
LIGHT BLUE | MID BLUE | SAFETY YELLOW | BUFF |
WHITE |
Technical Datasheets
Flowdur WR
Safety Data Sheets
Flowdur WR Hardener
Flowdur WR Aggregate
Flowdur WR Resin