Flowprime SF - Low Viscosity Epoxy Primer

Application Conditions

Resin products should not be mixed and laid outside of the range 10 °C to 25 °C. Localised heating or cooling equipment may be required outside this range to achieve ideal temperature conditions. To reduce the risk of “blooming” caused by condensation, the climate above the uncured floor should be maintained at least 3 °C above the dew point until subsequent toppings are applied.

Mixing

Add the hardener component to the resin component and mix using a low speed electric mixer (200 - 500 rpm) fitted with a mixing paddle designed to minimize air entrainment for 1 - 2 minutes until homogeneous. Care should be taken to ensure that any material adhering to the sides and bottom of the mixing vessel is thoroughly mixed in otherwise uncured patches may result.

Application

Once mixed the primer should be applied immediately in a thin continuous film Work the primer into the surface using a stiff brush or roller avoiding pooling. On porous surfaces Flowprime SF will be absorbed very quickly leaving dry patches. A second coat should be applied to these dry areas to ensure good adhesion and reduce the possibility of air release from the substrate causing bubbles or pin holing in the final topping

Technical Datasheets

Flowprime SF Technical Data Sheet

Safety Data Sheets

Flowprime SF Hardener

Flowprime SF Resin